BAOSHUN CARTON EQUIPMENT

 

TEL: +86-317-7896888 \ +86-317-7896666
FAX: +86-317-7723046
PHONE: +86-13931722296
E-MAIL: ceo
@hbbaoshun.com
ADD: Dongguang City Industrial Zone, Dongguang County, Hebei Province, China

Copyright © Baoshun Carton Equipment

冀ICP备17010139号-1

Power by 300.cn

TWENTY YEARS

OF PRODUCTION EXPERIENCE

Mobile Website

Wechat

>
>
>
Suggestions on Improving Three Kinds of Machining Faults of Veneer

Suggestions on Improving Three Kinds of Machining Faults of Veneer

Author:
Source:
Release time:
2018/11/13
[Abstract]:
If the wrinkles are caused by inconsistent tightness or wavy edges at both ends of the film, the qualified film should be replaced for the veneer.

1. If the wrinkles are caused by inconsistent tightness or wavy edges at both ends of the film, the qualified film should be replaced for the veneer.  

2. The two ends of the electric heating roll and the rubber roll are unbalanced, the pressure is inconsistent and the linear speed is unequal, which should be adjusted appropriately.    

3. The film transfer roll is unbalanced, so the transfer stick of the veneer should be adjusted.       

4. The adhesive layer is too thick and solvent evaporation is not complete, which affects the viscosity. When pressed by pressure drum, paper and film slide. The amount of glue should be adjusted to increase the drying temperature.